Miniature Photoelectric Sensors
Not To Be Used for Personnel Protection
Never use this product as a sensing device for personnel protection. Doing so could lead to serious injury or death.
This product does NOT include the self-checking redundant circuitry necessary to allow its use in personnel safety applications. A
sensor failure or malfunction can cause either an energized or de-energized sensor output condition. Consult your current Banner Safety Products
catalog for safety products which meet OSHA, ANSI and IEC standards for personnel protection.
Patented design allows for a sensor only one-third the size of the original
12 mm threaded barrel on most models.
Uses advanced miniaturized microprocessor-based circuitry.
Simple setup, using digital push-button sensitivity adjustment.
Available for opposed, retroreflective, diffuse, and convergent sensing modes.
Complementary outputs (one normally open and one normally closed), each with
150 mA switching capacity.
IP67 and NEMA 6 environmental ratings.
Wraparound status indicators.
Models with either integral, unterminated cable or 150 mm (6”) pigtail with 4-pin
Opposed-Mode Emitter (E) and Receiver (R) Models
Their small effective beam size is ideal for accuracy-dependent applications. They
provide enough excess gain at short range to burn through even contaminated areas
and may even sense opaque materials through a thin-walled container.
5 m
(16.5')
4 m
(13.2')
3 m
(9.9')
2 m
(6.6')
1 m
(3.3')
0
0
40 mm
80 mm
120 mm
40 mm
80 mm
120 mm
0
1.5"
3.0"
4.5"
1.5"
3.0"
4.5"
DISTANCE
QS12
Opposed Mode
* 9 m (30') cables are available by adding suffix
to the model number of any cabled sensor (e.g.,
A model with a pigtail QD requires a mating cable (see page 7).
Kommentare zu diesen Handbüchern