Banner D10 Series Bedienungsanleitung PDF herunterladen (Seite 6)

D10 Expert

™

Dual Discrete Outputs

6 P/N 64154 rev. F

Banner Engineering Corp. • Minneapolis, MN U.S.A.

www.bannerengineering.com • Tel: 763.544.3164

Push Button

Remote

0.04 sec. ≤ T ≤ 0.8 sec.

Result

Access SET

Mode

•Pressandhold

Static (-) button

> 2 seconds.

•Displayflashes“1st”

•Arrowiconturnsred

•Presentsensingcondition.

•Single-pulse

the remote line.

•Displayflashes“2nd”

•Arrowiconturnsred

SET Sensing Condition

•Presentsensing

condition.

•Double-clickthe

Static button.

•Double-pulse

the remote line.

TEACH conditions acceptable:

•Displayflashes“sngl,”

 then“pt” twice

•SensorreturnstoRUN

mode with new settings.

•Arrowiconturnsgreen

TEACH conditions unacceptable:

•Displayflashes“fail” and

 returnsto“1st”

•Arrowiconremainsred

•After60seconds,sensor

returns to RUN mode

(Arrow icon turns green)

without changing settings.

TTTT

TTT

TTTT

TTT

dynamic

static

dynamic

static

dynamic

static

dynamic

static

dynamic

static

dynamic

static

Single-Point Window SET

 •SetsasingleONconditionthatextends200countsaboveandbelowthetaughtcondition

(including ±100 counts hysteresis)

 •Allotherconditions(lighterordarker)resultinOFFoutput

•

Sensingwindow(sensitivity)isadjustableusing“+”and“-”buttons(seeManualAdjust,

page 9)

Window SET is most useful when a product may not always appear in the same place, or

when other signals may appear. Window SET designates a sensing window, with the Output

ON condition inside the window, and the Output OFF conditions outside the window (see

Figure 6). The sensor accepts a single sensing condition, and adds switching thresholds and

hysteresis above and below that condition to create a sensing window. Output ON and OFF

conditionscanbereversedbychangingLight/DarkOperatestatusinSETUPmode.

Window SET and Manual Adjust

Using Manual Adjust with Window SET expands or contracts the size of the window.

Sensor positions

window thresholds

± 100 counts from the

presented condition

Darkest

(no signal)

Most Light

(saturated

signal)

Taught

Condition

200 counts

Hysteresis

100 counts

Hysteresis

100 counts

Output OFF Output OFFOutput ON

Sensing window size adjusted by

Manual Adjust

Figure 6. Single-Point Window SET and

Hysteresis (Light Operate shown)

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

Banner D10 Series Bedienungsanleitung Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sensoren Banner D10 Series