Banner Q45 Series Bedienungsanleitung PDF herunterladen

45DN Bus Expansion Cards

For use with Q45X Photoelectric Sensors on DeviceNet

™

Bus Networks

Printed in USA 05/03 P/N 39667 rev. C

• Banner model 45DN plug-in bus cards enable a Banner Q45X Series sensor to

establish a logical relationship between the sensor’s output and other compatible

devices on a DeviceNet™ bus network.

• The following features of the 45DN are programmable via the network with a

configuration tool*:

Feature Range (default)

Network Address 0-63 (63)

Baud Rate 125K, 250K, 500K (125K)

Operate Mode** Light Operate or Dark Operate (Light Operate)

All 45DNs support the following connection type:

The Explicit Message Connection, which is required to Set and Get sensor

Attributes.

The 45DN1 supports the following connection type:

The Bit Strobe Connection, which responds to a master’s request.

The 45DN2 supports the following connection type:

The Change of State Connection, which responds to the slave’s change of state.

I/O Response (8-bit word of data):

Bit 0: 0 Output is OFF

1 Output is ON

Bit 1: 0 Alarm is OFF

1 Alarm is ON

Bits 2-7 Not used: always 0

* Configuration may be simplified through use of an Electronic Data Sheet (Banner

model EDS 40223)

** The Light/Dark Operate switch in the Q45 sensor must be set to the Light Operate

position (the factory setting).

Features

WARNING . . .

Not To Be Used for Personnel Protection

Never use these products as sensing devices for personnel protection. Doing so could lead to serious injury or death.

These sensors do NOT include the self-checking redundant circuitry necessary to allow their use in personnel safety applications. A

sensor failure or malfunction can cause either an energized or de-energized sensor output condition. Consult your current Banner Safety Products

catalog for safety products which meet OSHA, ANSI and IEC standards for personnel protection.

Model Part Number Used with Sensor Communications I/O Supported

45DN1 40059 All Q45XB6 models, except emitter DeviceNet Bit Strobe Connection

45DN2 49215 All Q45XB6 models, except emitter DeviceNet Change of State Connection

45DNE1 40907 Q45X6EQ emitter

Allows emitter to be powered from

DeviceNet bus; does not communicate

Models

1 2 3 4

Inhaltsverzeichnis

Seite 1 - 45DN Bus Expansion Cards

45DN Bus Expansion CardsFor use with Q45X Photoelectric Sensors on DeviceNet™ Bus NetworksPrinted in USA 05/03 P/N 39667 rev. C• Banner model 45DN plu

Seite 2 - Installation and Removal

Q45XDN ™2 P/N 39667 rev. CBanner Engineering Corp. • Minneapolis, MN U.S.A.www.bannerengineering.com • Tel: 763.544.3164The 45DN is one of a family of

Seite 3 - • Minneapolis, MN U.S.A

The Q45X sensor with 45DN expansion card installed requires DeviceNet-compatiblequick-disconnect cable, which is available from various manufacturers,

Seite 4 - P/N 39667 rev. C

Banner Engineering Corp., 9714 Tenth Ave. No., Minneapolis, MN 55441 • Phone: 763.544.3164 • www.bannerengineering.com • Email: [email protected]